Pitney Bowes N921 - Manual (Page 14)

Page 14
Installation Instructions
N900
series install
11.Plug power supply unit into outlet
Plug the power supply unit into the wall outlet and turn power on.
After a short power-up sequence, the display appears as shown.
Note: If the scale does not power-up, check that the power cable is firmly attached to
the control module. Also check that the wall outlet you are using has power by plugging
in another device.
10.Connect the meter cable to the postage meter
If using a postage meter, connect the
large end of the meter cable to the the
meter as shown. Tighten the
thumbscrews securely. If your postage meter is fitted with an
optional Datalink unit, connect the
large end of the meter cable to the
lower connector on the Datalink unit.
Tighten the thumbscrews securely.
B900
Datalink
B700
B900
DM series