Panasonic DMC-FX30 - Manual (Page 10)

Preparation
10
VQT1C08
Playback time
The number of recordable pictures and
playback time will vary depending on the
operating conditions and storing condition
of the battery.
∫ Charging
Charging time and number of recordable
pictures with the optional battery pack
(DMW-BCE10E) are the same as above.
• The [CHARGE] indicator lights when
charging starts.
∫ When the [CHARGE] indicator flashes
• When the battery temperature is
excessively high or low, [CHARGE]
indicator flashes and the charging time
will be longer than normal.
• The terminals of the charger or the battery
are dirty. In this case, wipe them with a dry
cloth.
• When the operating time of the camera
becomes extremely short even after
properly charging the battery, the life of
the battery may have expired. Buy a new
battery.
∫ Charging conditions
• Charge the battery in a temperature
between 10 oC to 35 oC. (The battery
temperature should also be the same.)
• The performance of the battery may
temporarily deteriorate and the operating
time may become shorter in low
temperature conditions (e.g. skiing/
snowboarding).
Inserting and
Removing the Card
(optional)/the Battery
• Check that this unit is turned off.
• Prepare a card. (optional)
• You can record or play back pictures
on the built-in memory when you are
not using a card. (P11)
1 Slide the release lever in the
direction of the arrow and open
the card/battery door.
• Always use genuine Panasonic
batteries (DMW-BCE10E).
• If you use other batteries, we cannot
guarantee the quality of this product.
2 Battery:
Insert it fully being careful about
the direction you insert it.
Pull the lever
A in the direction of
the arrow to remove the battery.
Card:
Push it fully until it clicks being
careful about the direction you
insert it.
To remove the card, push the card
until it clicks, then pull the card
out upright.
Playback time Approx. 300 min
Charging time Approx. 120 min
A
B