Panasonic DMC-FX30 - Manual (Page 97)

Others
97
VQT1C08
Message Display
Confirmation messages or error messages
will be displayed on the screen in some
cases.
The major messages are described below
as examples.
[THIS MEMORY CARD IS LOCKED]
The Write-Protect switch on the SD
Memory Card and the SDHC Memory Card
are moved to [LOCK]. Move the switch
back to unlock it. (P11, 78, 83)
[NO VALID PICTURE TO PLAY]
Record a picture or insert a card with a
recorded picture and then play it.
[THIS PICTURE IS PROTECTED]
Delete or overwrite the picture after
cancelling the protect setting. (P77)
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE
DELETED]
Pictures not based on the DCF standard
cannot be deleted. If you want to delete
some pictures, format the card after saving
necessary data on a PC etc. (P83)
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
You have exceeded the number of pictures
that can be set at one time with [MULTI] in
[DATE STAMP] or [MULTI DELETE].
Delete the set pictures or stamp the date
information on them and then do the
operation for any remaining pictures.
More than 999 favourites have been set.
[CANNOT BE SET ON THIS PICTURE]
DPOF print cannot be set for pictures not
based on the DCF standard.
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY ON
THE CARD]
There is no space left on the built-in
memory or the card.
• When you copy pictures from the built-in
memory to the card (batch copy), the
pictures are copied until the capacity of
the card becomes full.
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
• When a picture with the same name as
the picture to be copied exists in the copy
destination.
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
format the built-in memory on the PC or
remove the batteries without turning the
camera off. Format the built-in memory on
the camera again. (P83) The data on the
built-in memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognised by
the camera. Format the card again with the
camera after saving necessary data on a
PC etc. (P83)
[PLEASE TURN CAMERA OFF AND
THEN ON AGAIN]
This message appears when the camera is
not operating properly. Turn the camera off
and on. If the message persists, contact the
dealer or your nearest servicentre.
[MEMORY CARD PARAMETER ERROR]
Use a card compatible with this unit. (P3, 11)
• You can only use an SDHC Memory Card
if using cards with 4 GB or more capacity.