Panasonic PV DM2092 - Manual (Page 15)

15
Initial Setup
*Important:
If a remote control button does not work when pressed, press the button on the remote
and try the button again.
Manual Clock Set
If AUTO CLOCK SET was incomplete,
manually set the clock as follows.
Press ACTION on the Remote to
display SET CLOCK Menu screen. 1
Press to select the month
and press SET to set. In the
same manner, select and set
the date, year, time, and DST.
(Daylight Saving Time)
2
Press ACTION twice to start
CLOCK and exit. 3
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
Turn the unit
Power on. 1
Press and hold both PLAY and FF
on the unit for more than 5 seconds.
• The power will shut off.
• Please ignore “NO CASSETTE” warning.
2
Perform “Initial Setup” on page 14.
3
Note to CABLE system installer:
This reminder is provided to call the CABLE (Cable TV) System Installers attention
to Article 820-40 of the NEC that provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.
SET : SET
SELECT :
END : ACT I ON
SET CLOCK
DST : ON
SELE CT MONTH
DM2092 (P14-15)Initial setup.p65 2002/06/19, 14:52 15