Perle Systems Speed LE 1P - Manual (Page 30)

Page 30
Chapter 2 Installing Drivers and Host Cards
Removing Host Cards
To remove any SPEED LE or SPEED LE Express card from your system, proceed as
follows;
1. Turn off the power to your system and unplug the power cord.
2. Remove the system cover to expose the inside of the connector panel for host cards.
3. Disconnect any cables or connector boxes connected to the card you want to remove.
4. Undo the securing screw for the host card you want to remove then lift the card out of its
slot as shown in the next picture.
5. Repeat from step 3. until you have removed all the host cards you want.
6. Replace and secure the system cover.
7. Plug in the mains lead and turn on the power.
Removal of SPEED LE or SPEED LE Express card is now complete.
Note
The exact location of host card slots varies for different systems, for exact mechanical
details of your system, refer to your system documentation.
Warning
Dangerous voltages exist inside computer systems. Before
removing host cards from your system, turn off the power supply
and unplug the power cord.
Caution
Full anti-static precautions should be taken when handling host
cards.