Panasonic DP-C306 - Manual (Page 17)

17
Chapter 2 Sc
an/Email Operations
6
Connect the USB Flash Memory.
Push the Slot Cover to open it.
Plug the USB Flash Memory into the USB
Memory port as illustrated.
7
Select “USB Memory”.
z Only one storage device can be selected at
a time. When the “USB Memory” is selected
as the storage device, the scanned image
cannot be saved to the SD Memory Card
and Hard Disk Drive at the same time.
z If the setting of Function Parameter “70 SD/
USB Memory Function” (General Settings
> Key Operator Mode) is set to “No”, the
Confirmation screen displays the “Function
not available” error message and beeps.
z If you do not touch any key for 3 seconds, or
select “Close” on the Touch Panel Display,
the machine will display the previous
screen.
For more details, refer to General Settings
in the Operating Instructions (For Function
Parameters) of provided CD-ROM.
8
Press the Start key.
z When scanning from the Platen Glass, place
the next original and follow the instructions
described on the Touch Panel Display.
z The scanned image is saved in the following
directory of USB Flash Memory.
Directory: \PRIVATE\MEIGROUP\PCC\DI\IMAGE
z When printing PDF or high-compression
PDF data, install and set up the Memory
Card Print Utility. For details, refer to the
Help section of the Memory Card Print Utility
on the Document Management System CD-
ROM.
9
Remove the USB Flash Memory.
z Do not remove the USB Flash Memory while
the Access Indicator is flashing.
Continued on the next page...