Pioneer Elite SC-07 - Manual (Page 20)

Connecting your equipment 03
20
En
Connecting your TV and DVD player
The diagram shows a basic setup of this receiver together
with a TV and DVD player, with S-Video or composite
video connections. Different TVs and DVD players may
offer alternative connections. See also
Using the
component video jacks on page 23 if your TV and/or DVD
player has component video inputs/outputs. If your DVD
player offers multichannel analog audio outputs, see
Connecting the multichannel analog inputs on page 63.
1 Connect the MONITOR OUT video jack to a video
input on your TV.
Use a standard RCA/phono jack video cable to connect to
the composite video jack, or for higher quality video, use
an S-Video cable to connect to the S-Video jack.
2 Connect a composite or S-Video output on your
DVD player to the DVD VIDEO or DVD S-VIDEO input.
Connect using a standard video cable or an S-Video
cable.
3 Connect a coaxial-type
1
digital audio output on
your DVD player to the COAXIAL IN 1 (DVD) input.
Use a coaxial cable designed for digital audio.
4 Connect the stereo audio outputs on your DVD
player to the DVD AUDIO inputs.
Connect using a stereo RCA/phono jack cable.
• If your DVD player has multichannel analog outputs,
you can connect these instead. See also Connecting
the multichannel analog inputs on page 63.
LAN (10/100)
DIGITAL
SPEAKERS
CAUTION:
SPEAKER IMPEDANCE 6 Ω - 16 Ω .
ATTENTION:
ENCEINTE D'IMPEDANCE DE 6 Ω - 16 Ω .
OPTICAL
RS-232C
HDMI
COAXIAL
COMPONENT VIDEO
ANTENNA
PRE OUT
MULTI CH IN
A
XM
IR
CONTROL
SIRIUS
BD
IN
IN
IN
12 V
TRIGGER
IN
1
IN
2
IN
3
OUT
1
OUT
2
SOURCE
OUT
ZONE3/
SOURCE
OUT
3 1 ASSIGNABLE -
3 1 ASSIGNABLE -
(HDMI
CTRL)
ASSIGNABLE
ASSIGNABLE
(CD-R)
IN 4
(VIDEO1)
IN 3
(DVR1)
IN 2
(TV/SAT)
IN 1
IN 3 (DVR2)
IN 2 (CD)
IN 1 (DVD)
IN 1 IN 2
(OUTPUT
12V
TOTAL
50mA
MAX)
1
2
IN
1
IN
IN
2
OUT
OUT
(DVD)
P R P B Y P R P B Y
P R P B Y (VIDEO1)
IN 3
(VIDEO2)
R
ZONE 2 OUT MONITOR
OUT
PHONO
IN
CD
IN
DVD
IN
TV/SAT
IN
VIDEO1
IN
VIDEO2
IN OUT
DVR1
IN OUT
DVR2
IN OUT IN
CD-R/TAPE
SIGNAL
GND
ZONE 2
OUT
ZONE 3
OUT VIDEO
VIDEO S-VIDEO FRONT CENTER
SUBWOOFER
SURROUND SURROUND BACK
FRONT CENTER
CENTER L R FRONT B L R SURROUND BACK/ L R SURROUND
SUBWOOFER
SURROUND SURROUND BACK
(Single)
(Single)
L
L
R
SEE INSTRUCTION
MANUAL
L
R
L
R
FM UNBAL 75 AM LOOP
SELECTABLE
VOIR LE MODE
D'EMPLOI
SELECTABLE
MONITOR
OUT
DVD
IN
VIDEO
IN 1 (DVD)
(DVR1)
IN 2
VIDEO
IN
S-VIDEO
IN
S-VIDEO
VIDEO OUT
AUDIO R L
ANALOG OUT
OPTICAL
DIGITAL OUT
COAXIAL
1
3 2 4
SC-07
DVD player TV
Note
1 If your DVD player only has an optical digital output, you can connect it to one of the optical inputs on this receiver using an optical cable.
When you set up the receiver you’ll need to tell the receiver which input you connected the player to (see The Input Setup menu on page 92).
SC07-05.book Page 20 Friday, April 25, 2008 11:59 AM