Pioneer DEH-P3100UB - Manual (Page 24)

Q factor
2W
—1W—1N—2N
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS in the audio function menu.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
LOW (low)
—MID (mid)—HIGH (high)—OFF
(off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been cancelled before
determination, operation is settled.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Press SW/BASS to display the subwoo-
fer setting mode.
Press
SW/BASS repeatedly to switch between
the subwoofer setting modes in the following
order.
SW SETTING 1 (subwoofer on/off setting) set-
ting mode
—SW SETTING 2 (subwoofer set-
ting) setting mode
2 Select SW SETTING 1 setting mode.
3 Turn MULTI-CONTROL to select the de-
sired setting.
NORMAL (normal phase)
—REV (reverse
phase)
—OFF (subwoofer off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been cancelled before
determination, operation is settled.
Note
You can also switch to this setting mode in the
menu that appears by using
MULTI-CONTROL.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SW SETTING 2.
1 Press SW/BASS to display the subwoo-
fer setting mode.
Press
SW/BASS repeatedly to switch between
the subwoofer setting modes in the following
order.
SW SETTING 1 (subwoofer on/off setting) set-
ting mode
—SW SETTING 2 (subwoofer set-
ting) setting mode
2 Select SW SETTING 2 setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL repeatedly to switch
the segment in the following order:
Cut off frequency
—Level
4 Turn MULTI-CONTROL to adjust the se-
lected segement.
Cut off frequency
50HZ
—63HZ—80HZ—100HZ—125HZ
Level
+6 to
–24 is displayed as the level is increased
or decreased.
Audio Adjustments
En
24
Section
03