Pioneer DEH-P3100UB - Manual (Page 26)

Adjusting initial settings
1 Press SRC and hold until the unit turns
off.
2 Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)
—AUX1 (auxiliary input 1)
—AUX2 (auxiliary input 2)—SW CONTROL
(rear output and subwoofer controller)
—
EVER SCROLL (ever scroll)
—BT AUDIO (Blue-
tooth audio)
—PIN CODE INPUT (pin code
input)
—BT VER INFO (Bluetooth version infor-
mation)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
# To cancel initial settings, press BAND/ESC.
# BT AUDIO, PIN CODE INPUT and
BT VER INFO can be selected only when Blue-
tooth adapter (e.g., CD-BTB200) is connected to
this unit.
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select
CLOCK SET in the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press
MULTI-CONTROL, one
segment of the clock display is selected.
Hour
—Minute
As you select segments of the clock display,
the selected segment blinks.
4 Turn MULTI-CONTROL to put a clock
right.
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 29.
1 Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker lead out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL/
PREOUT :REAR) or subwoofer
(
REAR SP :SUB W/PREOUT :SUB W) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL). When rear
output is connected to full range speakers
(when
REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
’s (low pass filter,
phase) built-in PREOUT :SUB W or the auxili-
ary PREOUT :REAR.
Initial Settings
En
26
Section
04