Panasonic AG-HSC1UP - Manual (Page 33)

33
VQT1F36
Setup
The power can be turned on and off with the LCD
monitor when the mode dial is set to
.
ª To turn on the power
Open the LCD monitor.
The status indicator A lights and the power turns
on.
ª To turn off the power
Close the LCD monitor.
The status indicator A goes off and the power
turns off. (If [QUICK START] (l 33) is set to
[ON], the unit goes into quick start standby mode
and the status indicator lights green.)
≥The power will not turn off while recording a
motion picture even if the LCD monitor is
closed.
Quick start
When quick start is ON the battery power is still
being consumed, even when the LCD monitor is
closed.
This unit will resume recording/pause mode
about 1.7 seconds after the LCD monitor is
reopened.
≥When in quick start standby mode about
70% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
≥This is only activated in the following case.
– When the mode dial is set to and an
SD card is inserted.
1
Press the MENU button, then
select [SETUP]
# [QUICK START]
# [ON] and press the cursor
button.
2
Close the LCD monitor while the
mode dial is set to
.
The status indicator A lights green and the
unit goes into quick start standby mode.
≥The lens cover does not close.
Turning the power on and off with
the LCD monitor
Set the mode dial to OFF when this unit is not
being used.
A
A
A
VQT1F36_ENG_PP.book 33 ページ ２００７年２月２６日 月曜日 午前１１時２９分