Setting date and time, L 41) – Panasonic AG-HSC1UP User Manual

Page 41

Advertising
background image

41

VQT1F36

Setup

Setting date and time

When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥Move the cursor button up or down to select

[YES], press the center of the cursor button and
then perform steps 2 and 3 below to set the
date and time.

If the screen shows the incorrect date and time,
then adjust it.

¬

Rotate the mode dial to select

.

1

Press the MENU button, then
select [BASIC]

#

[CLOCK SET]

#

[YES]

and press the cursor

button.

2

Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.

≥The year will change as follows:

2000, 2001, ..., 2039, 2000, ...

≥The 12-hour system is used to display the

time.

3

Press the cursor button to enter
the selection.

≥The clock function starts at [00] seconds

when the cursor button is pressed.

≥After pressing the MENU button to finish

the setting, check the date and time
display.

Changing the date and time display style

Press the MENU button, then select [SETUP]

#

[DATE/TIME]

# desired display style and press

the cursor button.
≥You can also show or change the date and time

display by repeatedly pressing the DATE/TIME
button on the remote control.

Changing the display style

Press the MENU button, then select [SETUP]

#

[DATE FORMAT]

# desired display style and

press the cursor button.

≥The date and time function are driven by a

built-in lithium battery.

≥Make sure to check the time before recording.
≥If the time display becomes [- -], the built-in

lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.

To recharge the built-in lithium battery:

If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)

[DATE]

[D/T]

[OFF]

Display style

Screen display

[Y/M/D]

2007.12.15

[M/D/Y]

DEC 15 2007

[D/M/Y]

15.12.2007

DEC 15 2007 3:30PM

DEC 15 2007

VQT1F36_ENG_PP.book 41 ページ 2007年2月26日 月曜日 午前11時29分

Advertising