Panasonic KX-HCM10 - Manual (Page 110)

Operating Instructions
110
When Top Page
does not
appear. • Enter the correct IP address in the web browser.
• IP address and Subnet Mask of the PC and the Network
Camera must be in the same class of the private IP address on
the LAN. Refer to page 25.
• The network congestion prevents Top Page from appearing
quickly. Wait for a while.
• A proxy server may prevent you from connecting directly to
Network Camera, set up not to use the proxy server. Refer to
page 26 for details.
• When Top Page does not appear, port number 80 might not be
available. Ask your ISP for the available port number.
• When you use DDNS, you need to set Default Gateway and
DNS server address. Refer to page 54 for Network window.
• If Top Page does not appear in the above procedure, press the
CLEAR SETTING button and set up with the Setup CD-ROM
again.
• The procedure on page 115 can be established if Network
Camera has a defect.
When forgetting
the IP address
of the Network
Camera. Check an IP address by using the Setup CD-ROM. Network
Camera List window on page 29 can tell you the IP address of
Network Camera.
When forgetting
the password to
access Setup
Page. Follow the steps below.
1. Initialize Network Camera by pressing the CLEAR SETTING
button.
2.
Reconfigure Network Camera.
Power Indicator
does not light
up. • Confirm that the standard AC adaptor PQLV10 (Order No.
PQLV10Y) is used.
• Confirm that the Indicator Control is disabled. Refer to page 84
for Indicator Control window.
Ethernet
Indicator does
not light up. • Ethernet cable is not connected properly.
• PC, Ethernet hub or broadband router is not working.
About Network Camera Setup
Problem Cause and Remedy