Panasonic KX-HCM10 - Manual (Page 20)

Operating Instructions
20
2.3 How to turn on Network Camera for
Installation
Connect the DC plug of the AC adaptor to the DC IN jack and a category 5 straight/
cross cable to the Ethernet port. Connect the AC plug of the AC adaptor to the
power outlet to turn on Network Camera. Pan/Tilt moves to the center position.
Ethernet Indicator turns on when the network is active.
Notes
• AC adaptor is used as the main disconnect device, so ensure that the
power outlet is located/installed near the equipment and is easily
accessible.
• Use only the specified Panasonic AC adaptor PQLV10 (Order No.
PQLV10Y).
• When you set up Network Camera in [Type 3], connect it temporarily in
[Type 1], [Type 2] or [Type 4].
• When Ethernet Indicator is off, confirm that the Ethernet cable is properly
connected, or PC, Ethernet hub or broadband router is properly working.
• Thread the AC adaptor line through the hook upward if it is convenient.
Thread the AC adaptor
line through the hook
downward.
Connect a category 5
cable to the Ethernet port.
AC adaptor
Power
Outlet
DC plug