Panasonic KX-HCM10 - Manual (Page 87)

Operating Instructions
[For assistance, please call: 1-800-272-7033] 87
3.5.14 Update Firmware
Update Firmware window allows the user to install the latest version of the
Network Camera internal operating system. In most cases, this will never be
necessary. Changes may be necessary to accommodate new operating systems
or new web browsers that are not shown on page 10. In those cases, Update
Firmware would be available from the Network Camera Technical Support Site at
http://panasonic.co.jp/pcc/en/. Check the current firmware version on Setup
Page on page 50.
Notes
• Do not turn off the power during Update Firmware. If the operation of
Update Firmware is stopped, refer to page 112.
• Buffered Images are erased when performing Update Firmware.
1.
Download the proper firmware from the Network Camera Technical Support
Site mentioned above.
2. If Network Camera is accessible from the Internet, temporarily disable access
and connect Network Camera to the PC as the following figure. This will
eliminate any interruption during the Update Firmware.
Note
When Network Camera uses the DHCP function, change the Internet
connection from DHCP to Static in Network window. Refer to page 54 for
the network parameters.
3.
Access Setup Page by entering "http://IP Address (or URL):Port No./
config.html" on the web browser and press [Enter].
• When port number is 80 (default), you do not need to enter port
number.
Ethernet hub
Without Ethernet hub, you should use category 5 cross cable.
Broadband Router
or
or
Category 5 straight cable