Procom AL500HYLA - Manual (Page 2)

2 AL058-01
SAFETY INFORMATION
PRODUCT IDENTIFICATION
1. Check the heater completely and thoroughly for
damage. DO NOT run a damaged heater.
2. DO NOT alter the heater or operate a heater that
has been modified from its original condition.
3. Use only propane gas.
4. Use only vapor withdrawal propane gas. If any
question, contact your LP dealer.
5. Do not use this heater as a wood-burning heater.
Use only the logs provided with the heater.
6. Inspect hose assembly before each use of the
heater. If there is excessive abrasion or hose is cut,
STOP USING HEATER! Replace with a new hose.
7. This heater is for outdoor use only. Even so make
sure that there is ample fresh air ventilation. Do not
use in buildings, garages or other enclosed spaces.
8. In the event that gas odor is detected,
IMMEDIATELY STOP operation until gas supply
has been located and corrected.
9. Do not place the heater where directly exposed to
water spray, rain, dripping water or wind.
10. Maintain minimum clearance to people or normal
combustible material (like paper) of 2 feet.
11. Place heater on a stable, level surface.
12. You must operate the heater with the heater
screen in place. Make sure heater screen is in
place before running heater.
13. This heater is designed to be smokeless. If logs
ever appear to smoke, turn off heater and call a
qualified service person. Note: during initial
operation, slight smoking could occur due to log
curing and heater burning manufacturing residues.
14. Do not attempt to move, handle or service while
heater is hot or in operation.
15. Use only in accordance with local codes or, in the
absence of local codes, with the National Fuel Gas
Code ANSI223.1-1996.
16. Do not hang or attach clothing or any other
flammable materials on or near the heater.
17. Carefully supervise young children when they are
in the vicinity of heater.
18. Heater becomes very hot while running. Keep
children and adults away from hot surface to avoid
burns or clothing ignition.
19. Installation and repair should be done by a
qualified service person. The appliance should be
inspected before use and at least annually by a
qualified service person. More frequent cleaning
may be required as necessary. It is imperative that
control compartment, burners and circulating air
passageways of the appliance be kept clean.
LOCAL CODES
UNPACKING
Install and use heater with care. Follow all local codes.
In the absence of local codes, use the latest edition of
The National Fuel Gas Code, ANSZ223.1, also known
as NFPA54*.
Available from :
American National Standards Institute, INC.
1430 Broadway, New York, NY10018
National Fire Protection Association, INC.
Batterymarch Park Quincy. MA 02269
1. Remove top inner pack.
2. Slide stove out of carton and set it on the flat floor.
3. Remove protective packaging.(See FIG.2)
4. Remove plastic wrap and carton from MID base.
5. Turn the door knob clockwise, open heater door to
take out log set, Remove all protective plastic wrap.
6. Unwrap log set by cutting plastic ties.
7. Check for any shipping damage. If stove or log is
damaged, promptly inform dealer where you bought
the stove.
Figure 2- shipping fireplace