Procom AL500HYLA - Manual (Page 5)

5 AL058-01
8. Set the top panel in place on the columns and
secure with M4 10 screws provided. Do not
tighten at this time. (See FIG.8)
12. From the outer side, use M5 10 screws to
fasten the fixing hoop on the right and left support.
Fasten the other side of the fixing hoop after the
cylinder is in place. (See FIG.11)
Note: The installer must supply an external regulator
with a hose (with 5/8” nut at one end, and a regulator
at the other end) and a 20# Vertical Acme with OPD
LP cylinder.
1. Turn the door knob clockwise and open heater
door.
2. Remove dustproof wrap from regulator.
3. Set cylinder flat on base compartment (See FIG.12)
4. Connect regulator with cylinder. Tighten with care.
Do not over-pressurize the valve.
5. Before opening gas supply valve, make sure
control knob is in the OFF position. Open gas
supply valve. Apply a mixture of liquid soap and
water to all joints. Do not use an open flame.
Bubbles forming show a leak. Check all
connections for leaks immediately.
9. Attach the screens to columns with M4 10
screws provided. Do not tighten at this time. (See
FIG.9)
10. Tighten the screws of step 8,9,10 to finish
installation.
11. Attach the handle to the middle base with 2 hex
head screws provided. (See FIG.10)
Figure 8-Top panel installation
Figure 9-Screens installation
Figure 10-Handle installation
Figure 11-The fixing hoop installation
Figure 12-Cylinder set and pipe
installation
CONNECTING TO GAS SUPPLY