Procom AL500HYLA - Manual (Page 3)

3 AL058-01
INSTALLATION
TOOLS REQUIRED:
Philips screwdriver
Wrench
Check if you have the items listed below before
installation.
Logs: 10 4 14 self-tapping screw: 5
M4 10 screw: 32 M5 10 screw: 4
Column: 4 Log grate: 1
Fixing hoop: 1 Hex head screw: 2
Handle: 1 Screen: 4
Caution: Some of the steel edges may
be sharp. Please use caution when
assembling the unit.
INSTALLATION INSTRUCTIONS:
1. Remove grate out of base and set flat on floor.
2. Take log foam package out of base. Please note
each log fits the number marked on foam package.
3. Unscrew the 16 screws that attach the top panel
and the middle base with short columns. Remove
top panel and short columns. Then set flat on the
floor. (See FIG.3)
Note: Short Columns and Self-tapping Screws are
used for packing only.
4. Place grate on burn plate. Make sure to line up the
red mark and five holes of grate with that of burn
plate. Then secure grate to burn plate with 5 4
14 Self-tapping Screws. (See FIG.4)
PRODUCT FEATURES
SAFETY PILOT
The heater has a pilot with a safety shutoff system.
The safety pilot is a required feature for outdoor
heaters. It shuts off the heater if flame is extinguished
by rough wind.
PIEZO IGNITION SYSTEM
This heater has a piezo igniter. This system requires
no matches, batteries, or other sources to light heater.
Figure 4-Place grate on burn plate
Figure 3-Burner fixing plate