Panasonic AJ-HD1400E - Manual (Page 21)

21
VANC data recording/playback
VANC data recording
1
Detects the VANC data packets that multiplex recorded
in the following range of the Y stream of HD SDI.
1080i: L9–L20, L571–L583
720P: L9–L25
<Note>
HANC data packets are not be detected.
2
Records VANC data packets up to the following volume
in the VAUX region of the DVCPRO HD format in the
order of the earlier line.
1080i: 5760 word/frame
720P: 2880 word/frame
<Note>
Data packets that exceed the capacity will not be
recorded or played back.
3
Records the video signal from the HD SDI simultaneously.
<Note>
Recording and playback of VANC data only are not
possible.
VANC data playback
1
If the VTR mode is one of the following, VANC data will
be multiplexed to the Y stream of the HD SDI and will be
played back with the video signal.
z Normal playback mode
z Simultaneous playback mode
z Edit playback mode
z EE mode
<Notes>
z If an operation mode other than the above, such as FF,
REW, JOG, VAR, the video signal will only be played
back by muting VANC data.
z Playback of VANC data only is not possible.
2
VANC data packets will be multiplexed to the same line
of the multiplex line.
<Notes>
z For format conversion playback, the video signal only
will be played back by muting VANC data.
z Metadata recorded on the tape will be output giving
UMID information first priority. When metadata is
output, set to a line other than the original multiplexed
line or select “BLANK.”