Pioneer VSX-817-S/-K - Manual (Page 46)

The System Setup menu 06
46
En
If you didn’t make component video
connections according to the defaults above,
you must assign the numbered input to the
component you’ve connected (or else you may
see the video signal of a different component).
For more on this, see
Using the component
video jacks on page 16.
1 Select COMP. IN from the IN ASSIG. menu.
2 Use / to select the number of the
component video input to which you’ve
connected your video component.
The numbers match the numbers beside the
inputs on the back of the receiver.
3 Select the component that corresponds
with the one you connected to that input.
• Use the
/
buttons and ENTER to select
DVD , TV , DVR or OFF .
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver’s
COMPONENT
VIDEO MONITOR OUT jacks.
The Other setup menu
The Other menu is where you can make
customized settings to reflect how you are
using the receiver.
1 Select OTHER from the System Setup
menu.
2 Use / to select the setting you want to
adjust then press ENTER .
If you are doing this for the first time, you may
want to adjust these settings in order:
• DRC – Specify the amount of dynamic
range adjustment to Dolby Digital or DTS
soundtracks (see
Dynamic Range Control
Setup below).
• DUALMONO – Isolate one channel when
listening to discs with dual mono encoding
(see
Dual Mono Setup below).
• LFE ATT – Set the attenuator level for the
LFE channel ( LFE Attenuator Setup below).
3 Use / to make the adjustments
necessary for each setting, pressing RETURN
to confirm after each screen.
Dynamic Range Control Setup
• Default setting: OFF
Specifies the amount of dynamic range
adjustment to Dolby Digital or DTS
soundtracks:
• DRC OFF – No dynamic range adjustment
(use when listening at higher volume).
• DRC MAX – Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased).
• DRC MID – Mid setting.
Dual Mono Setup
• Default setting: CH1
Specifies how dual mono encoded Dolby
Digital soundtracks should be played:
1
• CH1 – Only channel 1 is played
• CH2 – Only channel 2 is played
• CH1 CH2 – Both channels are played
through the front speakers
LFE Attenuator Setup
• Default setting: ATT 0 dB
Set the LFE attenuator as necessary to prevent
ultra-low bass tones (included with some
Dolby Digital and DTS audio sources) from
distorting the sound from the speakers:
• LFEATT 0 – No limiting (recommended
setting)
• LFEATT 10 – 10 dB of limiting
• LFEATT ** – No sound from LFE channel
Note
1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.
VSX517_817.fm 46 ページ ２００７年２月２２日 木曜日 午後８時１１分