Pioneer VSX-817-S/-K - Manual (Page 9)

5 minute guide 02
9
En
English
Français
Deutsch
Nederlands
Italiano
Español
There are several other sound options you can
select. See
Listening to your system on page 31
for more on this.
1
See also The System Setup
menu on page 39 for more setup options.
Using the Quick Setup
VSX-517 model only
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes the
necessary settings after you have selected your
speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to
The System Setup menu on page 39.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP .
3 Use the MULTI JOG dial to choose your
subwoofer setting.
Select YES or NO , depending on whether
you’ve connected a subwoofer.
4 Press ENTER .
5 Use the MULTI JOG dial to choose your
speaker setup.
If you selected YES for the subwoofer setting in
step 3, the following choices are available:
2.1ch – 3.1ch – 4.1ch – 5.1ch
If you selected NO for the subwoofer setting in
step 3, the following choices are available:
2.0ch – 3.0ch – 4.0ch – 5.0ch
• Check the table below to find the speaker
setup that corresponds with your system.
6 Press ENTER .
7 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (
S , M or L ), M being
an average-sized room.
8 Press ENTER.
9 Use the MULTI JOG dial to choose your
listening position.
You can cycle between the following choices:
• FWD – If you are nearer to the front
speakers than the surround speakers
• MID – If you are equal distance from the
front and surround speakers
• BACK – If you are nearer to the surround
speakers than the front speakers
10 Press ENTER to confirm your setup.
The display shows the speaker setup, room size
and listening position that you have selected.
Note
1 Depending on your DVD player or source discs, you may only get digital 2 channel stereo and analog sound. In this case, the
listening mode must be set to
STANDARD (it should already be set – see Listening in surround sound on page 31 if you need to
do this) if you want multichannel surround sound.
STANDBY/ON
PHONES
DVD/LD DVD 5.1 TV / SAT DVR / VCR
MIDNIGHT/
LOUDNESS VSB MODE SOUND RETRIEVER
DIALOGUE ENHANCEMENT PHASE CONTROL AUTO SURR/ DIRECT
QUICK
SETUP SETUP RETURN
TONE
TUNER EDIT SIGNAL
SELECT DIMMER
MULTI JOG
PHASE CONTROL
UP DOWN
MULTI JOG
MASTER
VOLUME
ENTER
VSX-517
STANDARD ADVANCED
SURROUND STEREO/
F.S.SURR
LISTENING MODE
TUNING STATION
VSX517_817.fm 9 ページ ２００７年２月２２日 木曜日 午後８時１１分