Panasonic SC-BT203 - Manual (Page 12)

12
RQT9371
Connections to a Set Top Box, etc.
Use the following connections when you want to output the original surround audio from your Set Top Box, cable TV, VCR, DVD recorder, etc.
through this unit’s speakers.
≥Do not connect through the video cassette recorder.
Due to copy guard protection, the picture may not be displayed properly.
≥Turn off all equipment before connection.
L R
COMPONENT VIDEO OUT
Y
AUX(TV)
P R
P B
SPEAKERS
+
-
ANT EXT LOOP AM AV OUT
R L CENTER
3 Ω 3 Ω
WOOFER FRONT
6 5 2 1
GND ANT LOOP
R L 3 Ω
SURROUND
4 3
R L 3 Ω
SURROUNDBACK
8 7 AC IN
TRANSMITTER
DIGITAL
VIDEO OUT
OPTICAL
2(STB) 1(TV)
DIGITAL IN FM ANT 75Ω ) (
3 Ω SUB-
OPTICAL
OUT
OPTICAL 2(STB)
TV
Optical digital
audio cable
(not included)
STB, VCR, DVD recorder, etc.
Refer to the operating instructions of the respective devices
for the optimal connections.
Main unit
≥This unit can decode the surround signal from the Set Top Box (Satellite receiver, Cable box, etc.).
Press [EXT-IN] several times to select “D-IN 2” (DIGITAL IN 2*).
* “(CABLE/SAT)” is displayed next to DIGITAL IN 2 when set for CABLE/SAT AUDIO input. (> 28, Setting the TV audio for VIERA Link
“HDAVI Control”)
≥For connections between this unit and the TV, refer to “TV connections”. (> 10, 11)
≥If you have various sound sources and this unit’s terminals are not sufficient, connect them to the available inputs on the TV and the
TV output should then be connected to the “AUX(TV)” or “OPTICAL 1(TV)” terminal of the main unit.
Refer to the operating instructions of the TV, video cassette recorder, DVD recorder or Set Top Box for settings to output its audio via
AUDIO OUT or OPTICAL OUT terminal of the TV.
– In some cases the audio signal will only be output as 2ch audio from the TV. In this case, connect the Set Top Box (Satellite
receiver, Cable box, etc.) that will be used most commonly with multi-channel audio to this unit’s “OPTICAL IN 2(STB)” terminal.
TIPS
Getting s
tar
te
d
BT300.book 12 ページ ２００９年３月２３日 月曜日 午後１時５７分