Panasonic SC-BT203 - Manual (Page 7)

7
RQT9371
Assembling the speakers
[BT300] \BT303\ : Front speakers
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform
assembly on it.
≥For assembly, use a Phillips-head screwdriver (not included).
≥For optional wall mount, refer to page 46.
≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have
strong enough support. Improper attachment may result in damage to the wall or speakers.
e.g. Caution
≥Do not stand on the base. Be cautious when children are near.
e.g.
Speaker assembly option
≥Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the
speakers.
Preventing the front speakers from falling
2 Front speakers 2 Stands
(with cables) 2 Bases 8 Screws
Make sure you have all the indicated components before starting assembly, setup, and connection.
Keep the screws out of reach of children to prevent swallowing.
1
2
2
1
1
Slide into the groove.
Press into the groove.
Tighten securely.
Tighten securely.
Position the cable
between the ridges.
Leave about 120 mm (4 23 /
32
)
Insert the wire fully.
: White
: Blue
Push!
Slide into
the groove.
Press into the groove.
Tighten securely.
Insert the wire fully.
: White
: Blue
Push!
Leave about 120 mm (4 23 /
32
)
You can remove and use the cable
from the stand. To reattach the
cable, refer to page 46.
Thread the speaker cable
through the base. Attach the speaker.
NOTE
Do
Not
Screw eye
(not included)
Wall
Approx.
150 mm
(5
29 /
32
)
Rear of the speaker
String (not included)
Thread from the wall to the speaker and tie tightly.
DO
NOT
Getting s
tar
te
d
BT300.book 7 ページ ２００９年３月１２日 木曜日 午後６時３４分