Pioneer VSX-39TX - Manual (Page 59)

59
OPERA
TION
5 Select the name of the company
that makes your component.
If there are two pages of company names, use the
page +/– buttons to go back and forth between the
two sets of makers' names. For explanation purposes,
we'll use PIONEER as an example.
6 Press the NUMBER 1 button.
If the component you are trying to control turns on/
off, the set up for this component is complete, but
components that don't have a standby mode can't
respond in this way. To test if you've set it up properly
work through step 8. Then try using selecting the
function you just set up (for example a CD player) and
using the controls on this remote control. If the
component does not respond, try working through the
procedure again and pressing number 2 instead this
time. Continue this procedure until one of the com-
mands works.
If none of the commands seem to work, try the
learning mode to program the component into the
remote control. This is explained on the following
page.
To go back a screen
press the BACK button.
To exit the process without inputting the com-
mands
press the BACK button repeatedly.
7 Press the SETUP OK button and the
screen returns to SELECT
FUNCTION so you can program
another component into the remote
control.
Repeat the process for all of your components.
You may find you have components which do not
correspond to the name on any function button (for
example a cable TV tuner) or you have two compo-
nents where only one button is provided (MD/TAPE 1).
In this case, use step 3 to assign any available
function button to the component you want to remote
control.
For example, you may have a cable TV tuner and one
video deck in your system. It would make sense to
assign the VCR 2 function button to your cable TV
tuner in step 3. The rest of the procedure is the same
as before. Choose CATV in step 4. The only practical
difference in this method is that you have to remem-
ber the VCR 2 function button is actually your cable TV
tuner.
In this case, you would need to hook up your cable TV
tuner to the input jacks marked VCR 2.
This method should help you customize the remote
control for your system.
8 Press the BACK button repeatedly
to leave the PRESET RECALL set up
mode.
Remote Control of Other Components
5
6
7
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Preset Recall [ DVD/LD]
SETUP
OK
DVD
SELECT NUMBER
MAKER
ITEM
NUMBER
PIONEER
BACK
1
2
7 8
9
5
1
6
10 11 12
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Preset Recall
PAGE
1 / 1
SAM-
SUNG
PIONEER TOSHIBA
ITEM
SELECT MAKER
MAKER
SHARP
SONY
PANA-
SONIC
DVD
PIONEER JVC AKAI RCA
BACK DVD/LD] [
«
BACK
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
RECEIVER