Pentax R-315(N) - Manual (Page 61)

59
8 INITIAL SETTING
16.Selection for Automatic illumination power-off
function : [ILLU. OFF]
Select the time interval (3, 5, or 10 minutes) for activating
the automatic illumination power-off function, or select
NIL, disabling the function.
17.Selection for Distance measurement buzzer :
[DIST. BUZ]
Select whether to enable or disable the beep when the
prism receives a light during distance measurement or
during repeated distance measurement.
18.Selection for H. angle 90° buzzer : [QUAD BUZ]
Select whether to enable or disable the beep at every
90° during angle measurement.
19.Selection of Distance measurement signal :
[MEAS. SIGNAL]
Select whether to display a signal indicator or AIM value
to be displayed from when distance measurement is
started to when measured data is displayed.
20.Selection of Automatic distance measurement :
[AUTO MEAS.]
Automatic distance measurement repeats measurement
automatically when the telescope has been collimated at
the prism. Select NIL, MEAS or TRACK.
21.Selection for priority Display : [PRIORITY DISP]
Select the display order of the sets of display items
which pressing the [DISP] key cycles through. The set of
display items selected here appears first after the power
is turned on.
22.Selection of the Coordinate axis as XYZ, YXZ, NEZ or
ENZ
Select the coordinate axis as XYZ, YXZ, NEZ, ENZ.
This [COORD.AXIS] is only for the PSF software.
1. MARK
2. VALUE
1. NIL
2. MEAS
3. TRACK
1. HA HD VD
2. HA VA SD
3. HA VA HD
SD VD
1. 3 MIN
2. 5 MIN
3. 10 MIN
4. NIL
1. ON
2. OFF
1. OFF
2. ON
1. XYZ
2. YXZ
3. NEZ
4. ENZ
PENTAX R-300 (p53-64) 10/30/02 11:13 AM Page 59