Pentax R-315(N) - Manual (Page 42)

5-5 Displaying the % Slope of the Vertical Angle
Press [F5] [MODE] to enter mode B.
Press [F2] [ANG SET] to display the Angle
setting screen.
Press the [F5] [SELECT] to change the
screen to display the slope % of Vertical
angle.
Press [F4] [DISP] to display the slope value in
%.
● The 0% represents the horizontal 0, and +100% and -100% represent 45° up
and down slopes respectively.
● To return the screen from the slope (%) display to the 360° scale, also take
above same steps by entering mode B.
● If the slope (%) exceeds [+/-]1000%, “Out of grade range” is displayed,
indicating that the current vertical angle cannot be measured.
● When the telescope returns to a slope within slope [+/-] 1000%, the slope (%)
display returns automatically from the “Out of grade range” message to the
numeric value.
40
5 ANGLE MEASUREMENT
S. FUNC ANG SET HOLD CORR MODE
MODE B 15 ° C S0
H
. angle
2 0 " 3 0 ' 9 2
°
H
. dst.
V
. dst.
ANGLE SET
1.ANGLE / %GRADE : ANGLE
2.H. ANGLE INPUT : 0 9 2
°
3 0 ' 2 0 "
3.R/L REVERSE : RIGHT
SELECT
MODE A 15 ° C S0
H
. angle
2 0 " 3 0 ' 9 2
°
H
. dst.
V
. dst.
MEAS TARGET 0 SET DISP MODE
MEAS TARGET 0 SET DISP MODE
MODE A 15 ° C S0
H. angle
2 0 " 3 0 ' 9 2
°
%. grade
- 1 . 8 4 %
S. dst.
PENTAX R-300 (p20-52) 10/30/02 11:08 AM Page 40