Paradyne 6342 - Manual (Page 113)

B. Configuration Defaults and Command Line Shortcuts
6300-A2-GB20-10 November 2003 B-5
nat basic {enable | disable}
nat basic map public-ip private-ip
nat basic map lower-public-ip lower-private-ip upper-private-ip
nat basic purge
nat disable
nat napt address ip-addr
nat napt delete {udp | tcp} port
nat napt {enable | disable}
nat napt map { udp | tcp} server-ip [ port ]
nat napt purge
nat purge
nat timeout [ time]
packet processing {enable | disable}
password {admin | operator} password
ping dest-ip [ mgt | -x source-ip] [-l bytes] [ -w time] [-i {eth1 | dsl1}]
ppp authentication {chap | pap | both | none}
ppp ip {eth1 | dsl1 | passthrough} [mask] [no-dns]
pppoe {enable | disable}
ppp password [password]
ppp username [username]
proxy arp {dsl1 | eth1} [ enable | disable]
restart
save
show alarms
show arp [ip-addr ]
show arp timeout
show bridge
show config
show console
show dhcp {relay | server }
show interface {dsl1 | eth1}
show ip route [ip-addr ]
Table B-2. Command Line Shortcuts (3 of 4)
Command