Paradyne 6342 - Manual (Page 43)

6300-A2-GB20-10 November 2003 4-1
4
DSL Router Configuration
Examples
Configuration Examples
The Hotwire DSL Router configuration examples in this chapter include only a
few of the possible scenarios. This chapter covers some of the common
configurations. The command syntax will vary based on your network setup.
Configuration commands require the access level of Administrator-Config and
changes need to be saved while in configuration mode to take effect. Refer to
Chapter 2, Accessing the DSL Router .
The Hotwire DSL Router configuration examples include:
„ Basic Bridging Configuration Example
„ Basic Routing Configuration Example
„ Basic NAT Configuration Example
„ NAPT Configuration Example
„ Simultaneous Basic NAT and NAPT Configuration Example
„ Unnumbered DSL Interface with Proxy ARP Configuration Example
„ DHCP Relay with Proxy ARP Configuration Example
„ DHCP Server with Basic NAT Configuration Example
„ PPPoE Client with NAPT and DHCP Server Configuration Example
„ Downstream Router Configuration Example
„ IP Passthrough Configuration Example
Refer to Appendix A, Command Line Interface , for specific commands and their
syntax. Refer to Appendix B, Configuration Defaults and Command Line
Shortcuts , for specific command default settings and abbreviated command line
syntax.