Princeton SP-88 - Manual (Page 20)

Sustain pedal
When pedal assign is set as "sustain pedal " ,
it has the sustain effect when stepping on the
pedal. Release it to turn off sustain effect.
Soft pedal
When pedal assign is set to "soft pedal ", it
has the dampens the sound when stepping on the
pedal.
Start/stop pedal
When pedal assign is set to "start/stop pedal",
the pedal has the same function as the
[START/STOP] button.
Tempo/Tap pedal
When pedal assign is set to "Tempo/Tap Pedal
" ,the ACCOMP tempo will be set as last two
beat tempo before you press the pedal. If the
tempo is over (below) than 280 (30), set the
tempo to 280(30).
Note:
If you step the pedal successively when the style
is playing, the keyboard will count the tap tempo
according to the last beat you stepped on the
pedal.
Memory select pedal
If pedal assign is set to "memory select pedal",
it will load the 48 memory parameter starting
from M1-M6 when stepping on the pedal.
Volume pedal. Various functiosn can be assigned
to the volume connected to the VOLUME jack.
The polarity of the foot controller can also be
changed. Step on the volume pedal to control the
volume.
Synth
The SYNTH function provides the tools for
creating new tones. Simply select one of
the 328 tones and edit its parameters to create
your own original sound.
Press the [SYNTH] button. The SYNTH icon
appears on the LCD. The User Voice number
"USER Voice = 342 " displays on the lattice
area. Then, select the desired number with
the dial, the [+]/[-] button between 342-350 for
storing your own voice.
Press the [NEXT] button. The PCM Voice
number "PCM Voice = 001 " is highlighted
on the lattice area. Then, select the desired voice
with the dial, the [+]/[-] button between 001-328
to adjust its parameters.
Press the [NEXT] or the [BACK] button to
select these parameters: Vibrate Rate, Vibrate
Depth, Vibrate Delay , Envelope. Attack,
Envelope. Decay, Envelope. Release. The name
& value of current parameter are highlighted on
the lattice area. You can adjust the parameters
with dial, the [+] & the [-], and [0]-[9] button
between 000~127.
Press the [+] & the [-] button at the same time to
reset the parameter to the default value 64 of
each parameter. You can play the keyboard to
hear the effect while changing the parameters.
(See "Parameters table for SYNTH ").
Press the [SYNTH] button or press the [NEXT]
and the [BACK] button synchronously to exit
the SYNTH function. Then the SYNTH flag on
LCD goes out. A name and its number of the
User Voice selected above will display on the
voice line of lattice area.
All the parameters in SYNTH function can be
memorized while the power is off. Press the
[STORE] & [SYNTH] button at the same time to
reset the parameters to the default value.
Note:
After entering a [SYNTH] function, you are not
allowed to exit by pressing a button.
To edit other parameters, press the [NEXT] or