Panasonic MC-UL915 - Manual (Page 58)

- 15 -
Carrying Handle
Poignée de transport
Mango para transportar
Dust Bin
Godet à poussière
Contenedor de
la basura
Headlight
Luz
Dispositif
d’éclairage
Exhaust Filter
MC-V194H (inside)
Filtro de escape (dentro)
Filtre d’évacuation
(à l’intérieur)
Overload Protector
(Reset Button)
Protector contra sobrecargas
(Botón de restauración)
Protecteur de surcharge
(Bouton de remise en circuit)
Carpet/Bare Floor
Selector
Control para alfombra/
sin alfombra
Sélecteur tapis/plancher
ON/OFF Switch
Interrupteur
Interruptor de
encendido-apagado
Body Release
Pedal
Pedal de liberación
del mango
Pédale de réglage
de l’inclinaison du
boîtier
Air Turbine
Turbine à air
Turbina de aire
Dirt Sensor
Détecteur de
poussière
Indicador de polvo
QUICKDRAW
RELEASE button
Bouton de
dégagement rapide
QUICKDRAW RELEASE
botón de liberación
FEATURE CHART
Power Dirt Sensor Headlight Cord Length Bare Floor
120V AC (60Hz) Yes Yes 35 Ft Yes
Tableau des caractéristiques
Alimentation Détecteur de Dispositif Longueur du Position
poussière d’éclairage cordon plancher
120 V c.a. (60 Hz) Oui Oui 10,7m (35 pi) Oui
Diagrama de características
Voltaje Sensor de Luz Extensión Uso sin
basura de cordón alfombra
120 V c.a. (60 Hz) Si Si 10.7m (35 pi) Si
- 58 -
Cleaning Exterior and Tools
➢ ➢ Unplug cord from wall outlet.
➢ ➢ Clean exterior using a clean, soft cloth that has been dipped in a solution of mild
liquid detergent and water and wrung dry.
➢ ➢ DO NOT drip water on the vacuum cleaner and wipe dry after cleaning.
➢ ➢ DO NOT clean tools in dishwasher or clothes washer.
➢ ➢ Wash tools in warm soapy water, rinse and air dry.
➢ ➢ DO NOT use tools if they are wet.
➢ ➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ ➢ Remove lower plate. See: “Removing
and Installing Lower Plate”
➢ ➢ Cut off any hair, thread, string, carpet
pile, and lint entangled around
agitator with a pair of scissors.
➢ ➢ Remove agitator. See: “Replacing
Belt”
➢ ➢ Remove any string or debris located
on the end caps, washers or agitator
shaft.
➢ ➢ Reinstall agitator and lower plate.
See: “Removing and Installing Lower
Plate”
Cleaning Agitator