Panasonic WV-CW484 - Manual (Page 21)

FAR
NEAR
TELE
WIDE
Focus lever
Zoom lever
21
Image Adjustment
You can manually adjust the pan/tilt/azimuth angles, focus, and zoom while observing the con-
nected monitor.
Notes:
• When connecting an LCD monitor to adjust the camera images, use an L-type mini plug.
Straight type plugs are not available.
• Do not hold the camera by lens unit to adjust panning, tilting, or azimuth.
• The video output to the BNC will be interrupted while an LCD monitor is connected to the
monitor output jack.
• While an LCD monitor is connected to the monitor output jack, ELC (Electric Light Control)
becomes effective to obtain a proper focus. During focus adjustment, blooming or smear
on highlighted objects may be caused. However, ALC (Automatic Light Control) is effective
during the normal use, and blooming or smear is reduced.
• Adjust zoom and focus after adjusting panning and tilting. (Refer to Step 3 and 4.)
1. Connect an LCD monitor to the monitor
output jack.
2. Pan/tilt/azimuth adjustment
• Loosen the three screws locking the pan
and tilt tables.
• Pan and tilt the table to aim the camera
at what you need to watch.
• Turn the azimuth adjuster to obtain a
level image.
• Tighten the three screws after adjusting.
3. Zoom
• Unlock the zoom lever.
• Move the lever to adjust the zoom.
• Lock the lever.
4. Focus
• Unlock the focus lever.
• Move the lever to adjust the focus.
• Lock the lever.
LOCK
Panning table
Tilting lock screw
75
°
Panning lock screw
Monitor output Jack
(3.5 diam. mini jack)
Azimuth
(Angle adjuster)
21