Panasonic WV-CW484 - Manual (Page 8)

8
Do not use strong or abrasive detergents
when cleaning the camera body.
Use a dry cloth to clean the camera when
dirty. When the dirt is hard to remove, use a
mild detergent and wipe gently. Then wipe
off the remaining detergent with a dry cloth.
About the dehumidifying device
• The camera has dehumidifying device to
keep the inside at low moisture level,
preventing condensation and quickly dis-
sipating dew if produced.
• Dew may be produced depending on the
conditions of temperature, humidity,
winds, and rain, and it may take time to
dehumidify.
• Never seal the surfaces of the dehumidi-
fying device.
Turn the circuit breaker off which supplies
the camera with the power when abnormal
conditions are encountered.
Observe the following for installation.
• This apparatus is designed to be
installed under eaves. Install this appara-
tus under eaves to avoid direct sunlight.
• If this apparatus is installed outdoors
without eaves, ensure the same circum-
stances as being under eaves.
Avoid installing in the following locations.
• Locations where a chemical agent is
used such as a swimming pool
• Locations subject to steam and oil smoke
such as a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emis-
sions are produced
• Locations subject to strong magnetic
field or radio waves
• Locations where corrosive gas is pro-
duced
• Locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
within –10 °C - +50 °C {14 °F - 122 °F}.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your par-
ticular environment.
Make sure that the installation area is strong
enough to hold the camera, such as a con-
crete ceiling.
When the installation area is not strong
enough, reinforce and strengthen it or use
Mounting Bracket WV-Q114 (option) or
Ceiling Mount Bracket WV-Q166 (option).
Do not install the camera in a humid or
dust-laden environment.
Otherwise, lifetime of the internal parts may
be shortened.
Radio interference
When the camera is used near TV/radio
antenna, strong electric field or magnetic
field (near a motor or a transformer), images
may be distorted and noise sound may be
produced.
Mounting screws
Only the fixing screws are provided to fix the
camera with the provided mounting bracket.
It is necessary to procure screws or bolts to
mount the camera. Prepare them according
to the material and strength of the area
where the camera is to be installed. The
screws and bolts must be tightened with an
appropriate tightening torque according to
the material and strength of the installation
area.
Dehumidifying
device