Choosing the input signal, Listening to your system 06 – Pioneer 915 User Manual
Page 38
Listening to your system
06
38
En
Choosing the input signal
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
1
1
Press
SIGNAL SELECT
on the front panel
to select the input signal corresponding to the
source component.
Press repeatedly to select between:
•
AUTO
– This automatically switches to
DIGITAL
if a digital source is detected,
otherwise it remains on
ANALOG
.
•
ANALOG
– Selects the analog inputs.
•
DIGITAL
– Selects the digital input.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Note
1 • This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz), WMA9 Pro and DTS digital signal formats. With other
digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 15) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
STANDARD
ADVANCED
SURR
ST/DIRECT
/AUTO SURR
SIGNAL
SELECT
LISTENING MODE
VSX_815-915.book.fm 38 ページ ２００４年１２月８日 水曜日 午後４時３分