Resetting the main unit, Switching the speaker impedance, Additional information 13 – Pioneer 915 User Manual
Page 72
Additional information
13
72
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the TONE button,
press and hold the
STANDBY/ON button for
about three seconds.
3
When you see RESET? appear in the
display, press
ENTER
.
OK?
shows in the display.
4
Press
SYSTEM SETUP
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker
impedance
We recommend using speakers of 8
Ω
with this
system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω
impedance rating.
•
With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your
speakers are rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your
speakers are rated at 8
Ω
or more.
VSX_815-915.book.fm 72 ページ ２００４年１２月８日 水曜日 午後４時３分