Pecoware PECO BRUSH BLAZER TBB-3000 - Manual (Page 10)

OPERATION
WARNING !
READ THE SAFETY AND OPERATION PROCEDURES BEFORE USING THE PECO BRUSH
BLAZER. DO NOT LET ANYONE OPERATE THE PECO BRUSH BLAZER IF THEY HAVE NOT
READ AND ARE FAMILAIR WITH THE SAFETY AND OPERATION PROCEDURES. FAILURE TO
DO SAY MAY RESULT IN SERIOUS INJURY OR DEATH.
The PECO Brush Blazer is equipped with an operator presence switch located on the left steering
control handle. Your left hand must be on the left steering control handle at all times when
operating the machine. Removing your left hand from the left steering control handle will engage
the kill switch on the engine. This featured is designed and installed for your safety. Familiarize
yourself with the controls and descriptions in the section below.
KEY SWITCH THROTTLE
CONTROL
LEFT STEERING
CONTROL HANDLE
AND OPERATOR
PRESENCE SWITCH
RIGHT STEERING
CONTROL HANDLE
1. PLACE YOUR LEFT
HAND ON THE LEFT
STEERING CONTROL
HANDLE
2. PUSH THE
THROTTLE
CONTROL
FORWARD
3. TURN THE KEY
SWITCH TO THE
RUN POSITION AND
WAIT FOR THE FUEL
PUMP TO ENGAGE.
ONCE THE FUEL
PUMP IS ENGAGED,
TURN THE KEY TO
THE START POSITION
AND RELEASE
STARTING THE BRUSH BLAZER
10