Pecoware PECO BRUSH BLAZER TBB-3000 - Manual (Page 29)

PLEASE NOTE: These are only recommended replacement times. The replacement times on the
parts in this list will vary depending on the work environment and operating habits.
DESCRIPTION PART # HOURS REQUIRED
BANDED KEVLAR DECK BELT M0232 400 01
B SECTION KEVLAR PUMP BELT M0260 500 01
BANDED KEVLAR DRIVE BELT M0233 300 01
CUTTING BLADES TBB-0190 016 08
CUTTING TEETH TBB-0165 004 04
CUTTING BLADE SHCS K0297 025 16
(3/8”-16 x 3/4”)
HAMMER MODULE
TBB-0137 300 04
HAMMER MODULE PIVOT BUSHING TBB-0163 300 04
HAMMER MODULE WASHER TBB-0178 300 04
HAMMER MODULE SHCS K0298 300 04
(3/4”-10 x 2-1/4”)
HAMMER MODULE NYLOC NUT
K0302 300 04
(3/4”-10)
BLADE BAR
TBB-0135 600 02
BLADE BAR NYLOC NUT K1247 600 10
(1/2”-13)
ZINGA HYDRO OIL FILTER
U0030 050 01
KOHLER ENGINE OIL FILTER TBB-0239 200 01
(KOHLER# 1205001)
IGNITION SPARK PLUG
TBB-0236 200 01
(KOHLER# 1213202 RC12YC)
KOHLER PRE-CLEANER ELEMENT
TBB-0238 025 01
(KOHLER# 2408305)
KOHLER AIR CLEANER ELEMENT
TBB-0237 100 01
(KOHLER# 2408303)
KOHLER FUEL FILTER
TBB-0243 200 01
(KOHLER# 25 050 10S)
HYDRAULIC OIL
When replacing hydraulic fluid, the following grades and levels are approved for the Brush Blazer:
Mobil 1 Synthetic 5W-30, 10W-30, 15W-50
Amoco Ultimate 10W-40
Shell Gemini 10W-40, 15W-50
Helix Ultra 5W-40, 10W-40
Mobil Super HP 10W-40, 20W-50
Viscosity Oil 10W-40
Aero Shell 15W-50
The Brush Blazer comes equipped with Aero Shell 15W-50
29
SCHEDULED REPLACEMENT PARTS LIST