Pecoware PECO BRUSH BLAZER TBB-3000 - Manual (Page 14)

PUMP ADJUSTMENT
TRAVEL ADJUSTMENT:
1. With the machine securely supported on blocks, loosen the jam nut at the end of one or both
FRS rods to be adjusted.
2. Turn the FRS rods either clockwise or counter clockwise until the tracks do not move when the
machine idles.*
3. After making the necessary adjustments, tighten the jam nut at the end of one or both FRS
rods.
*If the machine travels forward when idling, the FRS rods should be turned clockwise until the
tracks do not move when the machine idles.
*If the machine travels in reverse when idling, the FRS rods should be turned counter-clockwise
until the tracks do not move when the machine idles.
*If the machine pulls to the left when traveling forward, adjust the right FRS rod by turning the rod
clockwise until the track does not move when the machine idles.
*If the machine pulls to the right when traveling forward, adjust the left FRS rod by turning the rod
clockwise until the track does not move when the machine idles.
REVERSE SPEED ADJUSTMENT:
1. With the machine securely supported on blocks, loosen the jam nuts on both reverse
adjustment bolts.
2. Turn the reverse adjustment bolts clockwise to slow the reverse speed or counter-clockwise to
increase the reverse speed.
3. After adjustment, tighten the jam nuts on the reverse adjustment bolts.
WARNING !
BEFORE ADJUSTING THE PUMPS ON THE BRUSH BLAZER, USE A FLOOR
JACK TO RAISE THE TRACKS OFF OF THE GROUND. USE BLOCKS UNDERNEATH
THE MOWER DECK AND THE REAR CHASSIS TO SUPPORT THE MACHINE.
WARNING !
DO NOT INCREASE THE REVERSE SPEED FASTER THAN
THE OPERATOR CAN SAFELY WALK BACKWARDS
FRS ROD
JAM NUT
JAM NUT
REVERSE
ADJUSTMENT
BOLT
HYDRAULIC
PUMP
14