Pecoware PECO BRUSH BLAZER TBB-3000 - Manual (Page 13)

OPERATION
THE BRUSH BLAZER CAN EASILY THROW STONES, STICKS AND OTHER DEBRIS AT
GREAT VELOCITY, POSSIBLY CAUSING PROPERTY DAMAGE OR PERSONAL INJURY.
DO NOT RUN THE BRUSH BLAZER OVER GRAVEL DRIVEWAYS, LOOSE STONES OR
MULCH WITH THE BLADES ENGAGED.
IF NECESSARY TO CLEAR DEBRIS FROM MOWER DECK, DISENGAGE THE BLADE,
TURN THE KEY SWITCH TO THE OFF POSITION AND DISCONNECT THE SPARK PLUG
WIRE.
WARNING !
BLADE ENGAGEMENT/DISENGAGEMENT
While holding the left steering control
handle with your right hand, reach down
and pull up on the blade engagement
control with your left hand.
While holding the left steering control
handle with your right hand, push the
blade control down with your left hand.
ENGAGEMENT
DISENGAGEMENT
PULL UP TO ENGAGE
PUSH DOWN TO
DISENGAGE
TIPS ON BRUSH CUTTING
OBSTACLES: Always check your work area before mowing and remove any debris that might
get tangled in or damage the machine. If the mower becomes tangled, turn off the engine and
disconnect the spark plug wire before reaching into the mower deck area.
SLOPES: Do not operate the brush blazer on slopes more than 20 degrees. If you have to
operate the machine on sloping terrain, move across the face of the slope, not up and down.
IF THE MACHINE GETS HUNG UP: Disengage the blade immediately. Try moving in reverse
and backing away from the obstacle.
CUTTING BRUSH AND SAPLINGS: The Brush Blazer can cut saplings up to 4” in diameter.
When cutting saplings or brush, allow the Brush Blazer to ride up and over the material slowly.
Adjust your forward speed to varying conditions. After cutting brush or saplings, you may want to
mow over it again to remove any remaining branches. It its recommended to mow from the trunk
end toward the top as the brush lies on the ground.
CUTTING IN WET CONDITIONS: Use extreme caution when cutting in wet or slippery
conditions. Avoid steep slopes or other slippery areas. Use a lower speed when conditions are
wet or slippery.
13