Pecoware PECO BRUSH BLAZER TBB-3000 - Manual (Page 22)

CHARGING THE HYDRAULIC SYSTEM
TOOLS REQUIRED:
(1) AIR COMPRESSOR
(1) AIR HOSE WITH 1/4” FEMALE COUPLER
(1) CONTAINER FOR COLLECTING FLUID
(1) HYDRAULIC CHARGING KIT
PROCEDURE:
1. Loosen, but do not remove the charge relief valve on both hydraulic pumps. Figure 1
2. Disconnect the return line. Attach a hose to the end of the return line and use a suitable
container to collect any fluid leakage that may occur. Figure 2
CONTACT YOUR BRUSH BLAZER DEALER FOR THE HYDRAULIC CHARGING KIT
ORDERING INFORMATION:
?
HYDRAULIC CHARGING KIT (PART#: TBB2-0068) INCLUDES:
(1) 1/4” AIR REGULATOR WITH GAUGE (PART#: TBB2-0067)
(1) 1/4” FEMALE COUPLER (PART#: TBB2-0066)
(1) 1/4” MALE PLUG (PART#: TBB2-0063)
(1) HYDRAULIC OIL TANK CAP WITH FITTING (PART#: TBB2-0065) INCLUDES:
(1) HYDRAULIC OIL TANK CAP DRILLED FOR 1/4” NPT (PART#: TBB2-0064)
(1) 1/4” MALE PLUG (PART#: TBB2-0063)
LOOSEN THE
CHARGE
RELIEF VALVE
FIGURE 1
DISCONNECT RETURN
LINE AND ATTACH HOSE
TO CONTAINER
FIGURE 2
DO NOT EXCEED MORE THAN 10 POUNDS OF PRESSURE WHEN
CHARGING THE HYDRAULIC SYSTEM. FAILURE TO DO SO MAY
RESULT IN SYSTEM FAILURE AND/OR PERSONAL INJURY.
DANGER !
22