Panasonic DMR-EZ37V - Manual (Page 57)

57
RQT8849
Connection and Setting
Perform steps 1–5 of “Clock Settings”.
Set Clock Automatically
,  to select “Set Clock
Automatically”, then
ENTER
ENTER to start auto setting.
The following screen appears when the setting
is complete.
Set Clock Automatically
Clock Setting completed successfully.
4/4/2007 11:15 AM
DST----------- On
Time Zone---- EST
ENTER
,  to select “Other Functions”,
then
ENTER
,  to select “Setup”,
then
ENTER
,  to select “Setup”,
then .
,  to select “Clock Settings”,
then
ENTER
Clock Settings
With the unit stopped
Notes
 This may take some time, up to a few hours in some cases.
 If the following message appears
Setup
Setup
Audio
Display
TV Screen
VHS
Channel
Disc
Video No Yes
ENTER
Set Clock Automatically
12/14/2007 5:28 AM
DST----------- Off
Time Zone---- EST
Setting completed as follows.
Finish the setup with this clock time?
Note:Selecting“No”will start channel scanning
again and renew the clock time.
If the time is correct, press [ ] to select “Yes”, then press [ENTER].
– If you select “No”, auto setting starts again, then the above
screen reappears. Repeat this step until the correct time appears.
 If the clock is not correct, set the clock with “Adjust Time Zone”
( below) or “Set Clock Manually” ( 40).
Tips
 To cancel in the middle
Press [RETURN]. The unit then displays “Set Clock Manually”
screen ( 54, Manual Clock Setting).
 Time Zone
Time Zone shows the time difference from Greenwich Mean Time
(GMT).
EST (Eastern Standard Time)  GMT 5
CST (Central Standard Time)  GMT 6
MST (Mountain Standard Time)  GMT 7
PST (Pacifi c Standard Time)  GMT 8
AST (Alaska Standard Time)  GMT 9
HST (Hawaii Standard Time)  GMT 10
For other areas: xx hr
 DST (Daylight Saving Time)
If you select “On”, the clock is advanced one hour starting at
2 a.m. on the second Sunday in March and ending at 2 a.m. on the
fi rst Sunday in November.
Set the DST period manually when it varies according to regions
( 54).
Adjust Time Zone
Adjust the time zone ( 1 or 1) if it was not set correctly
with auto clock setting.
You can set this menu only after “Set Clock
Automatically” is completed.
Perform steps 1–5 of “Clock Settings”.
,  to select “Adjust Time
Zone”, then
ENTER
,  to select “1” or “1”
then
ENTER
Adjust Time Zone
0
Tips
To return to the previous screen
Press [RETURN].
To exit the screen
Press [RETURN] several times.
ENTER to complete.