Panasonic DMR-EZ37V - Manual (Page 78)

78
RQT8849
Error Messages
On the Unit’s Display
Page
H , F
(“ ” stands for a service
number.)  An error has occurred. The number following “H” or “F” depends
on the status of the unit. Check the items below and in the
Troubleshooting Guide. If the service number still does not
disappear after the check, reset the unit ( 67, “To restore the unit if
it freezes”).
−
 If the service numbers fail to clear, note the service numbers and
contact a qualified service person.
−
RC (“ ” stands for a number.)  The remote control and main unit are using different codes. Change
the code on the remote control.
67
HARD ERR
(“HArd” and “Err” are alternately
displayed.)  If there is no change after turning the unit on and off, consult the
dealer where the unit was purchased.
−
NO READ
(“NO” and “REAd” are alternately
displayed.)  The disc is dirty or badly scratched. The unit cannot record, play, or
edit.
65
 The disc may be incompatible or of poor quality. 62 to 64
 You have used a lens cleaner and it has finished operation. Press
[  OPEN/CLOSE] on the main unit to eject the disc.
3
 Displayed when the unit is started. This is not a malfunction. −
The unit is carrying out its recovery process. You cannot operate the
unit while “ ” is displayed.
−
FULL  There are already 16 scheduled recording programs. Delete
unnecessary scheduled recording programs.
18
UNSUPPORT
(“UNSUP” and “POrt” are
alternately displayed.)  You have inserted a disc the unit cannot play or record on. 62, 63
UNFORMAT
(“UNFOr” and “MAt” are
alternately displayed.)  You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW
(DVD-Video format) recorded on other equipment.
You can format the disc when the format confirmation screen is
displayed.
37
U59  The unit is very warm.
The unit switches to standby for safety reasons. Wait for about
30 minutes until the message disappears.
Reinstall the unit in an area with adequate ventilation. Do not block
the cooling fan on the rear of the unit.
−
U61  There was a power failure or the AC power supply cord was
disconnected while the unit was on. The unit is carrying out its
recovery process. This process restores the unit to normal operation.
The unit is not broken. Wait until the message disappears.
−
U88  There was something unusual detected with the disc while
recording, playing or copying; there was a power failure or the AC
power supply cord was disconnected while the unit was on. The unit
is carrying out its recovery process. This process restores the unit
to normal operation. The unit is not broken. Wait until the message
disappears.
69
U99  The unit fails to operate properly. Press [/I POWER] on the main
unit to switch the unit to standby. Press [ /I POWER] on the main
unit again to turn the unit on.
−