Panasonic DMC-FX700 - Manual (Page 157)

- 157 -
Advanced (Playback)
Touch [ 3]/[4] to set the number of prints, and then touch [SET] to
set.
• When [MULTI] has been selected, repeat steps 3 and 4 for each picture. (It is not
possible to use the same setting for a multiple number of pictures.)
Press [MENU] several times to return to the menu screen.
• Touch [EXIT] to close the menu.
∫ Canceling all the [PRINT SET] settings
1 Touch [CANCEL] on the screen shown in step 2 .
2
Touch [YES].
3 Touch [EXIT] to close the menu.
• You cannot select [CANCEL] if not even one picture has been set for printing.
∫ To print the date
After setting the number of prints, set/cancel printing with the recording date by touching
[DATE].
•
When you go to a photo printing store for digital printing, be sure to order the printing of the
date additionally if required.
• Depending on the photo printing store or the printer, the date may not be printed even if you set
to print the date. For further information, ask at your photo printing store or refer to the
operating instructions for the printer.
• The date cannot be printed on pictures stamped with text.
Note
• The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
• [PRINT SET] cannot be set for motion pictures.
• If the file is not based on the DCF standard, the print setting cannot be set.