Panasonic DMC-FX700 User Manual
Page 190
Others
- 190 -
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
•
This message will be displayed when you format the built-in memory on a PC.
> Format the built-in memory on the camera again.
The data on the built-in memory
will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
•
It is a format that cannot be used with this unit.
> Format the card again with the camera after saving necessary data on a PC etc.
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
•
This message appears when the camera is not operating properly.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
[MEMORY CARD PARAMETER ERROR]/[THIS MEMORY CARD CANNOT BE USED]
> Use a card compatible with this unit.
•
SD Memory Card (8 MB to 2 GB)
•
SDHC Memory Card (4 GB to 32 GB)
•
SDXC Memory Card (48 GB, 64 GB)
[INSERT SD CARD AGAIN]/[TRY ANOTHER CARD]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
> Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
Use a card with SD Speed Class
¢
with “Class 4” or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with “Class 6” or higher when recording motion pictures
in [MOTION JPEG].
¢ SD Speed Class is the speed standard regarding continuous writing.
•
In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format
.
•
Depending on the type of the card, motion picture recording may stop in the middle.