Planet Technology Internet Telephony PBX System IPX-300 Series - Manual (Page 12)

The IP PBX must access remote AP .Please be sure that have account to access from
remote AP. In this WISP & AP mode the network interface will change from WAN port to
LAN port and all of network access will through by remote AP.
¾ Step2. Internet Setting (AP Mode)
WAN Setting
NAT Mode
Network Address Translation (NAT) serves connecting multiple
computers to the Internet using one IP address.
Bridge Mode
Bridge mode serves to connect a local area network (LAN /
Wireless) to another local area network that uses the same
protocol.
WAN Port IP
Assignment
Three methods are available for Internet Access. Static IP /
DHCP / PPPoE type for your select .you should refer to “Network
Setting” in user menu.
Table 2-1. WAN description of IP PBX
Figure 2-3. Wizard-Internet settings
AP Setting (For IPX-300W)
For configuring correctly the WLAN port in client mode. the below instructions will provide a quick
start. It is advised if possible to use the simplest network settings for first try.
For making sure the IP PBX is connecting to your wireless router (AP). You need to set up the
following: SSID, Frequency Channel, Authentication method and Encryption parameters
(Type/Encryption length/Keys.)
12