Planet Technology Internet Telephony PBX System IPX-300 Series - Manual (Page 39)

When IP PBX operates in AP-Client (or WISP & AP) Mode, the
WAN and LAN RJ-45 interface will be configured as a 2 port
switch for connecting with 2 PCs for access wireless network.
Í
Note
WLAN Mode
For wireless connected type 802.11 B/G mixed/ 802.11b only /
802.11G only
Remote AP SSID Define the same as your Wireless Router uses
Remote AP MAC Define the same as your Wireless Router uses
Remote AP Key
Enter the remote AP Authorization Key (WPA-PSK / WPA2-PSK /
WPAPSK ,WPA2PSK Mix Mode to Show)
W-LAN Channel Define the same as your Wireless Router uses
W-LAN IP Assignment
1.DHCP client
2.Static IP Address
Static IP
Key in the W-LAN IP address, W-LAN Subnet mask and W-LAN
Gateway from WISP
DHCP Client
When the DHCP Client is enabled, the IP PBX will get the IP Address
from Outdoor AP of WISP
WLAN SSID
The service set identifier assigned to the wireless network (WLAN).
Default SSID is IPPBX
Hide SSID
Hide SSID prevents outside users from joining the network without
knowing the wireless Network's ID, default is check SSID
Authentication Method
Define the same as your Wireless Router uses. (OPEN / SHARED
Mode)
Encryption Type
Define the same as your Wireless Router uses. (OPEN / SHARED
Mode
Table 4-7. WISP & AP mode description
39