Setting slic con trol mode, Setting com pander mode, Setting slic control mode – Paradyne JetFusion Integrated Access Device User Manual
Page 151: Setting compander mode, Setting slic con- trol mode, Setting com- pander mode
2000-A2-GB20-10
- 132 -
February 2004
Setting
SLIC Con-
trol Mode
To set SLIC control mode (for POTS only), type T to display the SLIC
Control Mode Selection menu:
Figure 7–5. SLIC Control Mode Selection Menu
Type the option of the control mode to set.
1. The IAD saves the mode you’ve selected and displays the menu.
2. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
3. Reset the IAD (page
) when you finish voice path configuration.
Setting
Com-
pander
Mode
To set Compander Mode, type U to display the Compander Mode
Selection menu:
Figure 7–6. Start Mode Selection Menu
1. Type the option of the Compander mode to set.
2. The IAD saves the mode you’ve selected and displays the menu.
3. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
4. Reset the IAD (page
) when you finish voice path configuration.
*******************************************
SLIC Control Mode Selection
*******************************************
Current Control Mode = AUTO Control Mode
A. AUTO Control Mode
B. MANUAL Control Mode
NOTE
Voice gateway applications, such as CopperCom or
JetStream, overrides the value set by this command.
*******************************************
Compander Mode Selection
*******************************************
Current Compander Mode = u-Law
U. u-Law Mode
A. A-Law Mode
NOTE
If you are unsure which mode to use, check with your
telephone service provider. Normally, u-Law is used in North
America and a-Law is used in Europe.