Paradyne JetFusion Integrated Access Device User Manual
Page 166
2000-A2-GB20-10
- 147 -
February 2004
Figure 7–22. AAL2/LES Configuration Menu
Configuring the IAD for a Specific AAL2/LES Gateway
1. To configure the IAD for a specific gateway, type the option
corresponding with one of the gateways listed in the menu.
2. The IAD configures the voice gateway for the selected gateway and
displays the AAL2/LES Manual Configuration menu. Included in the
settings is a message indicating the IAD will be configured for the
selected gateway after reset.
3. Reset the IAD (page
) when you finish voice path configuration.
Manual Configuration
Type C to display the AAL2/LES Manual Configuration menu (current
settings eliminated from this example):
Figure 7–23. AAL2/LES Manual Configuration Menu
Type the option for the command to execute and proceed to the
appropriate section.
Enabling and Disabling Ports
************************************
AAL2/LES Configuration
************************************
AAL2/LES is MANUALLY configured.
Port Control (bit mapping) is 0x00000000
CAS signaling is GR303-ABCD.
CAS refreshing is DISABLED.
Idle CAS refreshing is DISABLED.
Max. CPS-SDU size is 0 octets.
"Combined use" timer is 0 millisecond(s).
User state control (USC) is DISABLED.
Dialled digit (outband) is DISABLED.
C. -MANUAL- Configuration
A. Accelerated Networks
L. Lucent
G. General Bandwidth
M. MetaSwitch
Z. Zhone
T. TdSoft
************************************
AAL2/LES Manual Configuration
************************************
P. Enable/Disable Ports
R. Set CAS refreshing rate
I. Enable/Disable idle CAS refreshing
S. Change Max. CPS-SDU Size; 45/64 Octets
T. Set "Combine Use" Timer
U. Enable/Disable User State Control
D. Enable/Disable Dialed Digit
A. Manual ATM Pace Control