Paradyne JetFusion Integrated Access Device - Manual (Page 236)

2000-A2-GB20-10 - 217 - February 2004
Route Table
Report
Type R to display the Route Table report in the Reports menu. The IAD
lists each route by IP address, and displays the following information about
statically configured routes and dynamically learned ones.
ARP Table
Report
Address Resolution Protocol (ARP) obtains the Ethernet MAC address for
a known IP address.
Type A on the Reports menu to display the following information about
mappings between Ethernet Media Access Control (MAC) addresses
(hardware addresses) and IP addresses.
Bridge For-
warding
Database
Report
To display information about mappings between Ethernet addresses and
devices connected to the LAN, type B on the Reports Menu. The IAD
displays the following information:
Table 12–26.Route Table Report
Parameter Description
Network Address destination address
Netmask IP subnet mask; no. of bits reserved for the host
ID
Gateway Address IP address of packets sent to destination
Interface IP address of outgoing interface
Metric no. of hops (routers) required to reach the
specified gateway
Type static | dynamic | RIP | local
Table 12–27.ARP Table Report
Parameter Description
IP Address IP address that corresponds to the MAC
address
Ethernet Address Ethernet address of the device; assigned by the
manufacturer
Interface The interface for the Ethernet address
Table 12–28.Bridge Forwarding Database Report
Parameter Description
Ethernet Address Ethernet address of the device; assigned by the
manufacturer
Interface Interface for the Ethernet address