Paradyne JetFusion Integrated Access Device User Manual
Page 168
2000-A2-GB20-10
- 149 -
February 2004
2. The IAD displays the AAL2/LES Manual Configuration menu. Included
in the settings is a message indicating that dialed digit will be enabled
or disabled after reset.
3. Reset the IAD (page
) when you finish voice path configuration.
Setting ATM Pace Control Manually
Type A to set ATM Pace Control manually. The IAD displays this menu:
Figure 7–24. Manual ATM Pace Control Menu
Type the option for the command to execute and proceed to the
appropriate section.
Enabling and Disabling Manual ATM Pace Control
1. Type P to enable or disable pace control.
2. The IAD displays:
Manual ATM pace control (disabled) [E/D]:
3. Type E to enable pace control, or D to disable pace control.
4. You must reset the IAD (page
) before this change takes effect.
Setting the Audio Bit Rate Margin
1. Type A to set the audio bit rate margin.
2. The IAD displays:
Audio bit rate margin (0):
3. Enter the new bit rate margin (0 to 50) and press Enter.
4. You must reset the IAD (page
) before this change takes effect.
Setting the Minimum Signaling Bit Rate
1. Type M to set the audio bit rate margin.
2. The IAD displays:
Minimum signaling bit rate (0):
3. Enter the new bit rate margin and press Enter.
4. You must reset the IAD (page
) before this change takes effect.
Debugging AAL2/LES Gateways
Displaying AAL2/LES Statistics
Type S to display the AAL2/LES Statistics menu:
************************************
Manual ATM Pace Control
************************************
Manual ATM pace control is disabled
Audio bit rate margin is 0%
Minimum signaling bit rate is 0bps
P. Manual ATM Pace Control
A. Audio Bit Rate Margin
M. Minimum Signaling Bit Rate
NOTE
The commands in option D, Debug Control, are reserved for
use by Paradyne network engineers only.