PreSonus Inspire 1394 - Manual (Page 28)

APPLICATIONS
28
4.2 MULTIPLE UNIT SUPPORT
It is possible to chain up to four INSPIRE 1394’s to allow for more input/output capability in your
DAW software. Install one INPIRE 1394 and give it a new name in the Control Panel’s Unit
Selector (click on the name and type a new name) so you can identify it, then, follow these steps to
install more units:
PC:
1.) Chain another INSPIRE 1394 via a 1394 cable to the available 1394 port on the
existing INSPIRE 1394. (Connect the power supply if not using buss power)
2.) An installer window will pop up that says INSPIRE 1394 WDM Driver. Follow the
instructions for this installer to complete the installation of the new device.
3.) Once the installer is finished, you should have a blue sync
light on both of the INSPIRE 1394’s connected.
4.) Open the INSPIRE 1394 Control Panel and look at the Unit
Selector. You should now be able to rename the new device
so you can identify it (click on the name to type a new name).
Repeat s 5.) teps 1-4 to add up to two more INSPIRE 1394’s.