Pitney Bowes W983 - Manual (Page 19)

16 SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
Use the following charts to determine the indicated settings for the
Stacker for various material lengths and thicknesses (where applicable).
0
6 5
Min.
7 8 9 10 11 12 13
Max.
1
2
3
4
5
6
7
8
9
10
11
Media Stop Setting
Material Length (in inches)
Media Stop Setting
3 4 5 6 7 8 9 10
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Full Arm Fixture Setting on Ramp
Material Length (in inches)
Full Arm Fixture Setting
The top chart is used to determine the setting for the media stop dependent on the
length of the material. The bottom chart is used to determine the setting for the full arm
fi xture dependent on the length of the material.
In order to use the charts:
1
Measure the length of your material in inches.
2 Go to the that length at the bottom of the chart and then up that line to where it
intersects the drawn line on the chart.
3 Follow a straight line to the left side of the chart from that intersect and that is the
setting that should be used for that adjustment.
Stacker_Dryer Op Guide Book.indb 16 Stacker_Dryer Op Guide Book.indb 16 3/30/2004 10:26:47 AM 3/30/2004 10:26:47 AM